Cisco A9K MPA 2x10GE jest wymiennym modułem wsadowym przeznaczonym do przekazywania w sieciach korporacyjnych. Moduł ten jest kompatybilny z szeroką gamą routerów Cisco ISR i może być wykorzystywany do przesyłania szybkich danych wymiennych w sieciach LAN i WAN. Moduł ma dwa złącza 10 Gigabit Ethernet, które są zgodne ze standardem IEEE 802.3ae, a także trzy złącza SFP +, które są kompatybilne z IEEE 802.3ae. Moduł jest wyposażony w dwa porty Ethernet, które są zgodne z IEEE 802.3ae i służą do przekazywania danych w sieciach LAN i WAN. Moduł może być również wykorzystywany do łączenia sieci do innych urządzeń, takich jak serwery, komputery, drukarki i inne urządzenia sieciowe. Moduł Cisco A9K MPA 2x10GE jest idealnym rozwiązaniem dla małych i średnich przedsiębiorstw, które potrzebują wydajnego i wysoce wydajnego przekazywania danych w sieciach LAN i WAN.
Bezpośredni link do pobrania Instrukcje dotyczące przekazywania Cisco A9k Mpa 2x10ge
Ostatnia aktualizacja Instrukcje dotyczące przekazywania Cisco A9k Mpa 2x10ge
Komentarz
Thanks for this video, a life saver
Thank you a lot, this was very very helpful.
Man, just wanna say your page and vid really helped me out. I appreciate it! Thumbs up!
How do you configure the access point to act as a standalone?
Fantastic video & how to on your blog. Would like to see a little more details on those ap-type commends on the video or the descr/comments, but easily findable on the blog.
Thank you for creating this video, very helpful!
Thank your for the video, well done! Do you know if is it possible to configure a single AP in both modes? As AP and WLC? Best regards!
Thanks for this informative video. Would you know if we can setup multiple vlans and map them to multiple SSIDs with EWC?
Until I saw your video, I could not get past the Day 0 setup. Nowhere in the Cisco setup documentation does it say you have to do the write mem to clear the day 0 setup flag. Once I saw your video with the write mem, I am now good to go! Thank you
really good video but the commands for creating users are quite different and doesn't work on new firmware Version 17.03.01 perhaps you can give some new advices
Is the Cisco DNA license required for the basic wireless function? Or is that only if you want to use the DNA features?
Hi, i try to follow your instructions for the 9115 model. Unfortunately in the console after bootup i don't have a prompt line. The AP after few minutes of booting stay in a loop of capwap discovery. How i can stop the discovery to obtain the prompt command line?
great information thanks
Thanks running through this now. Appreciate the vid! I couldnt find the doc on this procedure
Thanks , very helpfull
Will the embedded wlc being able to run dhcp from the ap rather than an SVI or dhcp server? I want to use this an ap on a stick for a pre-survey. An access point mounted on a camera light stand with wheels being power by an battery source. So once my device hits a particular signal db I know that is where I need to place another access points.
If i have more APs with the same model say 9115AXI-S, do i need to upgrade each AP's image that matches with the image of the virtual controller or existing EWC?
Thanks a lot for your information
I want to buy a CATALYST 9117AX SERIES.
This got me out fo a sticky situation when I turned up to install 3 APs that were all the lightweight version..!
.